Sorry, you need a Java-enabled browser to see the simulation.

This is a current mirror, a device that uses the current in one half of the circuit to control the current flow in the other half. The current is the same in both halves. The switch on the left changes the current flow in the left half, which is mirrored in the right half. The switch on the right causes the resistor to be bypassed, but the current mirror ensures that the flow of current does not change.

Q1's emitter-base junction acts like a diode. The current through it is set by the resistor network below it. Wiring the base to the collector ensures that the base current can flow, so the transistor can stay in the active mode. Since Q1's base is wired to Q2's, they are at the same voltage, so Q2's emitter-base junction must have the same amount of current flowing through it. (It acts like a diode, so the current is determined by the voltage across it.)

Both halves of the circuit have nearly the same current flowing through them. The only difference is that the base currents from Q1 and Q2 flow through the left half, and not the right half. We use high-beta transistors in this circuit to make these base currents as small as possible.

Next: Differential Amplifier
Previous: Current Source Ramp
Index




java@falstad.com
Generated Tue Feb 23 2010